News

How the GutRad StVO Module Works with Bafang BBS UART

How the GutRad StVO Module Works with Bafang BBS UART

How the GutRad StVO Module works with Bafang BBS UART

The GutRad StVO Module was developed for compatible Bafang BBS systems using the UART protocol. It does more than program a controller once: it establishes a defined operating state and checks the relevant controller data again whenever the system is switched on.

1. Existing controller data are saved

Before the initial adjustment, the module reads and saves the existing controller data. This backup allows an orderly return to the previous state, for example if a customer decides not to keep the module after a withdrawal from the purchase.

2. The GutRad parameter set is written

The parameters intended for the particular compatible BBS system are then written to the controller. The intended pedelec operating state takes account of:

  • a configuration for no more than 250 W rated continuous power;
  • pedal assistance ending no later than 25 km/h;
  • assistance only during the intended pedalling operation;
  • no normal throttle-driven riding function.

Starting assistance or walk assistance at up to 6 km/h must be considered separately.

3. Verification at every start

Each time the system is started, the relevant controller data are checked again. This distinguishes the GutRad concept from a one-off user programming operation.

4. Detected changes are overwritten

If the monitored controller parameters differ from the required values, the module writes the stored GutRad data set back to the controller. Changes to those parameters are therefore detected and overwritten at the next system start.

We deliberately avoid claiming that the system is universally “tamper-proof”. The specific technical function can be described much more precisely.

The GutRad Key is not a tuning switch

The GutRad Key is not required for the normal intended operation of the StVO Module. It is not intended to switch between pedelec operation and an unrestricted or tuned riding mode. Its main function is to support removal and restoration.

Why are the original settings saved?

The backup allows the controller state that existed before installation to be restored, for instance if the module is removed following a withdrawal from the purchase. Once that state has been restored and the module removed, GutRad makes no statement about the controller configuration subsequently used.

Permanent use

For permanent use, the original saved controller data can be overwritten with the GutRad StVO data set. The backup will then also contain only the GutRad configuration. Earlier unrestricted or deviating settings can no longer be restored from that backup.

What the GutRad documentation establishes

GutRad documents the operating state established and monitored by the module on the compatible drive system. That documentation does not itself exempt a fully converted bicycle from vehicle approval. Its legal classification depends on the actual technical properties of the complete vehicle.

Responsibility remains with the converter

The GutRad StVO Module is not an official vehicle approval. Anyone converting their own bicycle remains responsible for the technically sound condition of the complete vehicle. GutRad provides a defined, repeatedly verified and documentable state for its part of the drive system — no more and no less.

In practical use since 2019

According to the feedback and experience available to GutRad since sales began in 2019, we are not aware of a case in which a qualified inspector or technical expert objected specifically to the functioning of a properly used GutRad StVO Module. This experience is not an official approval or a legal guarantee.

Further information

This article provides general technical and legal information. It is not a substitute for individual legal advice or assessment of a particular vehicle.